v0.914037added testpoint for db2020 gdfs repair.

v0.914037added testpoint for db2020

---

v0.914037

- added testpoint for db2020 phones.
db2020 testpoint idea made by dre_ambox team.
as i respected that, i not included db2020 testpoint in setool2
for a long time. but anything ends sometime.
now, setool2 users can enjoy gdfs db2020 gdfs repair.

usage:
1. it is only and only for professionals.
users,advanced users, please "go away".
2. testpoint is +3.3 voltage, connected to specific pin.
we suggesting to use +3.3v battery
(battery ground MUST be connected with phone's GROUND)
3. go to emptyboard fill & repair.
4. select any db2020 model.
5. press "TP STAGE #1". read instructions and execute them.
6. press "TP STAGE #2". read instructions and execute them.
7. phone is BROWN now.
8. staying on "emptyboard fill and repair" write correct gdfs_in_ssw format.
9. if flashing went fine, flash db2020 erom with needed CID.
10. phone now retail and repaired. fullflash phone as usual.
testpoint pictures (courtesy of drea_mbox team) included.
after SETOOL2 db2020 testpoint procedure phone FULLY
working in "alternative security bypass" mode without ANY restrictions.

- greatly decreased locosto-based SEMC ODM phones security bypass time.
(instead ~50 seconds, now we have ~18 seconds)
- minor bugfixes.

RAPIDSHARE LINKLINK

just a simple way to make Testpoint.

---

[You must be registered and logged in to see this image.]
just a simple way to make Testpoint.
Just Use the SE-Tool cable,
Use pin number 8 for positive(+) and pin number 7 for negative(-) at RJ45 cable in SE-tool.
you dont need anything more.....
ups you need a needle too hehehe
here's the picture, just change the red "crocodile" with a needle then you have your self a Testpoint to use.
it's shows exactly a 3,3v
here is more clear
[You must be registered and logged in to see this image.]
__________________